AC-LVDT Signal Conditioner Takes On Power Generation Applications

Alliance Sensors Group introduces its latest LVDT signal conditioner, the S2A. The conditioner offers smart and fast LVDT/RVDT setup and has been engineered to work with the widest range of LVDTs, RVDTs, and inductive half-bridge sensors including 3-wire GE LVRTs and GE gas turbine buck-boost style LVDTs. The signal conditioning module has cyber security tamper prevention and notification features that no other manufacturers have even considered, providing confidence that the unit has not been compromised.

 

Operating Features:

SENSORS MIDWEST

Sensors Midwest Hits Rosemont, IL October 16-17!

Sensors Midwest, the industry's largest event focusing on sensors, design, and IIoT in the Midwest region, is scheduled for October 16-17 at the Donald E. Stephens Convention Center in Rosemont, IL. Co-located with STMA, the event draws over 1,000 engineers and engineering professionals that are looking for access to the latest sensor advancements and will provide an opportunity to connect with the area's greatest technology leaders and suppliers.
  • Push button calibration
  • Built-In null indication
  • 4 excitation frequencies, 8 analog DC outputs (6 DC voltage and 2 current loop outputs)
  • 16 addresses for RS-485 digital communications
  • Hot swap capability
  • Advanced master/slave capability to reduce cross talk  

S2A New Diagnostic Features:

  • Shorted primary,
  • Disconnected or open primary,
  • Shorted or grounded secondaries,
  • Disconnected or open secondaries,
  • Analog output shorts or opens,
  • Common hook-up errors that can occur during initial installation and setup.
  • Cybersecurity to prevent tampering and notify main system operations of tamper attempt.
  • Real-time recalibration to tweak the analog output after the mechanical system’s warmup.
  • Recalibration from the module’s front panel or over the RS-485 bus.
  • Differential input which common modes out most ground-loop developed noise signals.
  • Backward Compatible to perform exactly as the legacy S1A conditioner.  

Other features of the S2A include:

  • Color coded plug-in connections which permit easy pre-wiring in a rack and hot swapping
  • Self-diagnostics for LVDT winding failures or cable disconnection. 
  • Detected output errors or faults drive analog output out of range, which is especially important for applications using redundant LVDTs  

For more information, see the S2A datasheet and/or email [email protected].