Wireless Applications

G2 Launches New Wi-Fi Epsilon Products

July 15, 2009

The G2C543 low-power Wi-Fi SoC, G2M5437 module, and Icon Development Kit will allow designers to connect consumer electronic devices directly to the Internet or to future Wi-Fi personal-area network systems.

CAMPBELL, CA /BUSINESS WIRE/ -- Adding to its already successful low-power Wi-Fi Epsilon family of Wi-Fi RTLS chips, G2 Microsystems launched its new G2C543 low-power Wi-Fi SoC, G2M5437 module, and Icon Development Kit, which will make it easy for designers to connect consumer electronic devices directly to the Internet or to future Wi-Fi personal-area network systems.

Wi-Fi has become ubiquitous in the home, allowing a new category of devices to connect directly to the Internet or to a laptop through the emerging Wi-Fi PANs. Overcoming the range limitations of Bluetooth and the gateway requirements of other technologies, such as ZigBee, Wi-Fi can now be considered for applications such as home energy management and health monitoring, and for laptop PAN peripherals, such as mice, wireless speakers, and high-fidelity headphones.

Available now, G2 offers three ways to quickly and affordably embed ultra-low-power Epsilon Wi-Fi technology into battery-powered CE devices:

  • G2C543 SoC—The G2 Wi-Fi and networking SoC includes a 32-bit CPU, operating system, network stack, crypto accelerators, power management subsystem, real-time clock, and a versatile sensor interface, allowing it to serve as a networking slave or a stand-alone host.

  • Complete G2M5437 module—Drastically reduce design times with this low-power, low-cost Epsilon module, which includes a power amplifier and antenna, G2C543 SoC, 8 Mb flash memory and comes pre-certified for FCC and CE regulations and is tested for Wi-Fi Alliance WMM and WMM Power Save modes.

  • Icon Development Kit—Affordably and quickly add Wi-Fi to an applications processor-based design with the G2-IDK, which includes a small board, with standard interfaces (UART, SPI, SDIO) and an Epsilon module pre-loaded with the Icon application. Icon enables a G2 module to become a Wi-Fi networking interface for mains- and battery-powered devices. The platform is especially suited for use with 8- or 16-bit host applications processors that do not have the ability to connect to other Wi-Fi chips, or for use with 32-bit host processors that do not have enough additional bandwidth to run a network stack.

"G2 is a demonstrated leader in ultra-low-power Wi-Fi," said Geoff Smith, G2 founder and CEO.

"With our second-generation silicon and module, it is now faster and easier to deploy a new class of consumer-priced, Internet-enabled wireless devices like Internet radios, cameras, toys, health monitoring devices, home automation/energy management devices, and media center remote controls."

More G2C543 Facts

  • It is self-contained, incorporating the 802.11 b/g protocol, security, and TCP/IP stack, providing Wi-Fi capability on a single chip.

  • It only draws 4 µA in standby mode and can wake up and transmit a packet in less than 11 msec. This allows the G2C543 to provide low-latency Wi-Fi solutions, driven from alkaline batteries with extended battery life.

  • For simple devices, no other microprocessor is required as the application can reside on the G2C543. For applications already running on a microcontroller, even an 8-bit micro, the G2C543 offloads all Wi-Fi communications, allowing for fastest time to market.

  • This SoC is a derivative of G2 Microsystems' award-winning G2C547 integrated circuit, which earned a "Best Electronic Design 2008" award from Electronic Design magazine.

Epsilon Family products are available in volume now. The G2C543 SoC is housed in a 72-pin QFN package and is priced at $4.80 in volumes of 1 million units. The G2M5437 module is sampling now and is priced at $13 in 10K unit volumes, and the Icon Development Kits are value-priced at $129 each.

To learn more about the G2C543, contact sales@g2microsystems.com or visit the company's Web site.

About G2 Microsystems
G2 Microsystems helps connect products, people, and data through intelligent Wi-Fi integrated circuits that make it easy to Internet-enable anything. Its ultra-low-power Wi-Fi systems-on-a-chip are embedded in a range of battery-powered or microcontroller-based devices, including consumer electronics, real-time locating systems, and wireless sensors. Backed by top industry investors, the privately held firm is headquartered in Campbell, CA, and has R&D facilities in Sydney, Australia.

Add Comment


Sensors 2017 Call for Speakers



Twitter Feed

Find It Fix It Forum

Sensors invites you to join the Findit-Fixit Forum, where you can get answers to your sensing questions—concerning technologies, products, methods, applications, and services--and also offer help to your fellow engineers. The Forum covers all kinds of topics, from the basics to the extraordinary.

Join the discussion!

© Copyright 2016 Questex, LLC. All Rights Reserved. Sensorsmag. Privacy Policy | Terms of Use

If you are having technical difficulties or considerations, please contact the webmaster.